-
- News
- Books
Featured Books
- design007 Magazine
Latest Issues
Current IssueLevel Up Your Design Skills
This month, our contributors discuss the PCB design classes available at IPC APEX EXPO 2024. As they explain, these courses cover everything from the basics of design through avoiding over-constraining high-speed boards, and so much more!
Opportunities and Challenges
In this issue, our expert contributors discuss the many opportunities and challenges in the PCB design community, and what can be done to grow the numbers of PCB designers—and design instructors.
Embedded Design Techniques
Our expert contributors provide the knowledge this month that designers need to be aware of to make intelligent, educated decisions about embedded design. Many design and manufacturing hurdles can trip up designers who are new to this technology.
- Articles
- Columns
Search Console
- Links
- Events
||| MENU - design007 Magazine
Estimated reading time: 1 minute
Fresh PCB Concepts: Recommendations for Track Welding and Open Circuit Repair
Track welding is what some factories may opt for if they find an open circuit. The technique is to attach/stick/weld a thin piece of copper across the broken track. Sounds okay, right? But how reliable is the repair? And how does IPC cover this subject?
Well, IPC doesn’t have too much to add on this subject other than mentioning that the customer and supplier should agree whether repairs are acceptable or not. Therefore, if the customer does not advise it is not acceptable, then it is acceptable by default. In my experience, the issue is rarely discussed between the supplier and customer. The lack of front-end discussions all too often comes to light after the fact when anomalies are detected on the finished PCB assembly.
Poor repairs can lead to open circuits being supplied; even a “good” repair has a risk of failure under load conditions (vibrations, etc.) leading to potential field failures.
To repair a PCB, the operator must remove the solder mask properly to expose the copper. Plus, the solder mask must be removed in the correct area without exposing the adjacent track and this can lead to a risk of short circuits. Then, copper must be welded very accurately to a thin track and ensure good enough registration. Finally, there must be enough contact to the original track. Even if the repair is reliable, many times the track is reduced by more than the acceptable IPC allowance for reduction limits.
We recommend having in place a strict policy when it comes to track welding: Do not allow repair of open circuits or track welding. Period. Any supplier utilized should also have track welding terms in their specifications. There’s too much risk. If you’ve ever experienced a field failure and all the effort, time, and costs that occur, you would know it’s worth it.
It’s a nightmare no one wants to go through. In this case, the best part if it’s not cost driven in the same way other things are such as via plugging or very thick copper.
Michael “Mike” Marshall is a field application engineer at NCAB Group.
More Columns from Fresh PCB Concepts
Fresh PCB Concepts: Fostering Loyal Relationships with PCB Design EngineersFresh PCB Concepts: Sustainable PCBs—Raw Materials and Compliance Methods
Fresh PCB Concepts: The Pros and Cons of Gerber, ODB++, IPC-2581
Fresh PCB Concepts: PCBs for Harsh and Extreme Environments, Part 2
Fresh PCB Concepts: PCBs for Harsh and Extreme Environments, Part 1
Fresh PCB Concepts: Designing Controlled Impedance PCBs
Fresh PCB Concepts: Copper Coin for Dissipating Heat
Fresh PCB Concepts: How Large Does That Pad Really Need to Be?