Generating High-Quality Single Photons for Quantum Computing
May 14, 2019 | MITEstimated reading time: 4 minutes
MIT researchers have designed a way to generate, at room temperature, more single photons for carrying quantum information. The design, they say, holds promise for the development of practical quantum computers.
Image Caption: MIT researchers have designed a new single-photon emitter that generates, at room temperature, more of the high-quality photons that could be useful for practical quantum computers, quantum communications, and other quantum devices.
Quantum emitters generate photons that can be detected one at a time. Consumer quantum computers and devices could potentially leverage certain properties of those photons as quantum bits (“qubits”) to execute computations. While classical computers process and store information in bits of either 0s or 1s, qubits can be 0 and 1 simultaneously. That means quantum computers could potentially solve problems that are intractable for classical computers.
A key challenge, however, is producing single photons with identical quantum properties — known as “indistinguishable” photons. To improve the indistinguishability, emitters funnel light through an optical cavity where the photons bounce back and forth, a process that helps match their properties to the cavity. Generally, the longer photons stay in the cavity, the more they match.
But there’s also a tradeoff. In large cavities, quantum emitters generate photons spontaneously, resulting in only a small fraction of photons staying in the cavity, making the process inefficient. Smaller cavities extract higher percentages of photons, but the photons are lower quality, or “distinguishable.”
In a paper published today in Physical Review Letters, the researchers split one cavity into two, each with a designated task. A smaller cavity handles the efficient extraction of photons, while an attached large cavity stores them a bit longer to boost indistinguishability.
Compared to a single cavity, the researchers’ coupled cavity generated photons with around 95 percent indistinguishability, compared to 80 percent indistinguishability, with around three times higher efficiency.
“In short, two is better than one,” says first author Hyeongrak “Chuck” Choi, a graduate student in the MIT Research Laboratory of Electronics (RLE). “What we found is that in this architecture, we can separate the roles of the two cavities: The first cavity merely focuses on collecting photons for high efficiency, while the second focuses on indistinguishability in a single channel. One cavity playing both roles can’t meet both metrics, but two cavities achieves both simultaneously.”
Joining Choi on the paper are: Dirk Englund, an associate professor of electrical engineering and computer science, a researcher in RLE, and head of the Quantum Photonics Laboratory; Di Zhu, a graduate student in RLE; and Yoseob Yoon, a graduate student in the Department of Chemistry.
The relatively new quantum emitters, known as “single-photon emitters,” are created by defects in otherwise pure materials, such as diamonds, doped carbon nanotubes, or quantum dots. Light produced from these “artificial atoms” is captured by a tiny optical cavity in photonic crystal — a nanostructure acting as a mirror. Some photons escape, but others bounce around the cavity, which forces the photons to have the same quantum properties — mainly, various frequency properties. When they’re measured to match, they exit the cavity through a waveguide.
But single-photon emitters also experience tons of environmental noise, such as lattice vibrations or electric charge fluctuation, that produce different wavelength or phase. Photons with different properties cannot be “interfered,” such that their waves overlap, resulting in interference patterns. That interference pattern is basically what a quantum computer observes and measures to do computational tasks.
Photon indistinguishability is a measure of photons’ potential to interfere. In that way, it’s a valuable metric to simulate their usage for practical quantum computing. “Even before photon interference, with indistinguishability, we can specify the ability for the photons to interfere,” Choi says. “If we know that ability, we can calculate what’s going to happen if they are using it for quantum technologies, such as quantum computers, communications, or repeaters.”
In the researchers’ system, a small cavity sits attached to an emitter, which in their studies was an optical defect in a diamond, called a “silicon-vacancy center” — a silicon atom replacing two carbon atoms in a diamond lattice. Light produced by the defect is collected into the first cavity. Because of its light-focusing structure, photons are extracted with very high rates. Then, the nanocavity channels the photons into a second, larger cavity. There, the photons bounce back and forth for a certain period of time. When they reach a high indistinguishability, the photons exit through a partial mirror formed by holes connecting the cavity to a waveguide.
Importantly, Choi says, neither cavity has to meet rigorous design requirements for efficiency or indistinguishability as traditional cavities, called the “quality factor (Q-factor).” The higher the Q-factor, the lower the energy loss in optical cavities. But cavities with high Q-factors are technologically challenging to make.
In the study, the researchers’ coupled cavity produced higher quality photons than any possible single-cavity system. Even when its Q factor was roughly one-hundredth the quality of the single-cavity system, they could achieve the same indistinguishability with three times higher efficiency.
The cavities can be tuned to optimize for efficiency versus indistinguishability — and to consider any constraints on the Q factor — depending on the application. That’s important, Choi adds, because today’s emitters that operate at room temperature can vary greatly in quality and properties.
Next, the researchers are testing the ultimate theoretical limit of multiple cavities. One more cavity would still handle the initial extraction efficiently, but then would be linked to multiple cavities that photons for various sizes to achieve some optimal indistinguishability. But there will most likely be a limit, Choi says: “With two cavities, there is just one connection, so it can be efficient. But if there are multiple cavities, the multiple connections could make it inefficient. We’re now studying the fundamental limit for cavities for use in quantum computing.”
Suggested Items
Knightscope Caps Off Year with 6-Robot Expansion Contract
01/02/2024 | BUSINESS WIREKnightscope, Inc., a leading developer of autonomous security robots and blue light emergency communication systems, today announces a new expansion contract for 6 Autonomous Security Robots (ASRs) including 2 of its 5th Generation K5s and 4 K1 Hemispheres, bringing the total number of robots under contract for this client to 14.
Elementary, Mr. Watson: Slash Sheets a ‘Smorgasbord’ of Materials
05/15/2023 | John Watson -- Column: Elementary, Mr. WatsonSlash sheets touch on materials, one of my favorite areas of PCB design, and what I refer to as “the buffet of the PCB world.” After all, this smorgasbord of materials comes in an endless variety, with differing balances of reinforcement and resin, from different manufacturers and vendors, and from a variety of sources. Add the possibility of out-of-date or deteriorated panels, and it makes ensuring the quality of your next PCB design a real hit or miss.
Pusan National University Researchers Develop Way to Tune Energy Levels of Semimetals
03/28/2023 | PRNewswireType-II Dirac semimetals are quantum materials with unique energy level structures, such as a bulk Dirac point (BDP). However, these semimetals are unsuitable for real-life applications because their BDP is far off the "Fermi energy level."
WPI-MANA Demystifies Conductivity of Ruthenate Nanosheets, Moving Towards Next-generation Electronics
02/17/2023 | PRNewswireA research team at the International Center for Materials Nanoarchitectonics (WPI-MANA) has shed light on how electrical conduction in oxide nanosheets can be markedly affected by small changes in their atomic arrangement.
New Data Extracted from Old for Materials Databases
11/07/2022 | ACN NewswireA new approach uses data from one type of test on small metal alloy samples to extract enough information for building databases that can be used to predict the properties and potentials of new materials.