Basic Principles of Polymer Thick Film Flexible Circuits


Reading time ( words)

Polymer thick film (PTF) technologies have been used to manufacture printed circuits for decades. In fact, some of the very first circuits ever produced in volume were made by printing conductive inks patterned on an insulating substrate using a stencil. While the versatile nature of the materials used and the simplicity of the manufacturing process have made possible its continued use for more than six decades. In more recent decades, the technology has seen extensive use in the manufacture of inexpensive, polyester film-based membrane switches for electronic devices of every imaginable type, from hand-held calculators and computer keyboards to household appliances including microwave ovens and washers and dryers and beyond.

Polymer thick film circuits are similar in many ways to their rigid and flexible counterparts; however, because of the materials and processes, they have their own very specific design rules. Because most PTF processing is most commonly based on screen printing technology, the limits of design are intrinsically linked to the printed ink’s processing considerations and limitations. For example, there are the unique processing properties for conductive and resistive as well as insulating inks in terms of their thixotropy, which influence their printability. There is also the important consideration of the final values for the conductivity and/or resistivity of the ink used when cured. In addition, there are also the limits of the screen printing materials and the processes used.

Traditional screen printing methods are typically limited to the production of relatively course features (e.g., 250 µm). However, very fine-featured screen printed circuit technology has been reported down to ranges closer to 125 µm. For the foreseeable future, screen printing will remain an important technology for the manufacture of PTF circuits, both rigid and flexible. That said, inkjet printing is well positioned to augment time honored screen print methods. It also opens the door to realizing the possibility of producing circuits economically at a run unit of one, which has been one of the ideals of manufacturing. 

Read the full article here.


Editor's Note: This article originally appeared in the June 2014 issue of The PCB Magazine.

Share

Print


Suggested Items

3D Additive Electronics Manufacturing: Are We Nearing an Inflection Point?

05/28/2020 | Dan Feinberg, I-Connect007
Recently, Dan Feinberg was invited to attend a detailed and broadly informative webinar by nScrypt titled “The Strength of 3D-Printed Electronics," which covered the status and advances in the use of 3D printing for electronic device design and manufacture. nScrypt is an Orlando-based company founded in 2002 that focuses on 3D printing. Here’s what Dan learned from each of the speakers.

iNEMI’s PCB Roadmap Explained

05/01/2020 | Pete Starkey, I-Connect007
In an informative and enlightening webinar, iNEMI Project Manager Steve Payne was joined by Isola Group CTO Ed Kelley to explain, review, and discuss the details of the recently published “iNEMI 2019 Roadmap for Organic PCBs.” Pete Starkey provides an overview.

Congratulations to Bhanu Sood! Dieter Bergman IPC Fellowship Award Recipient

03/16/2020 | Patty Goldman, I-Connect007
Patty Goldman speaks with Dr. Bhanu Sood of NASA, Dieter Bergman IPC Fellowship Award recipient, about his extensive involvement with IPC on many committees developing standards to his work teaching professional development courses and mentoring young engineers.



Copyright © 2020 I-Connect007. All rights reserved.