The Readers Speak: Tips on Accelerating your Design Cycle


Reading time ( words)

This month, in addition to publishing feature articles by well-known experts in the field, we decided to collect feedback from the readers—PCB designers and engineers working in the trenches each day. We asked our readers to provide their favorite tips, tricks, and techniques for speeding up the PCB design cycle. Here are 10 tips for cutting your design time, courtesy of designers just like you. 

Matija Milostnik
PCB group leader, Slovenia
“Bang on the electrical engineers to squeeze out of them all constraint upfront before starting a design, so that you can put them into rules in the design tool, and then hold them accountable for changes. The rest is easy, in comparison.” 

Santiago Cervantes
CID+, San Diego
“Know the system the PCB integrates into.” 

Karl Bates
President of ConnectPCB, Chicago
“Use both hands (i.e., one hand on the mouse, other using shortcut keys or function keys). Type without looking at your hands (they should know where the keys are).” 

Jens Hansen
PCB designer, Aalborg, Denmark
“Learn the limitations of the PCB fabrication process and set up your PCB CAD system accordingly.”

Felipe Lopez Rendon
Packaging design engineer with Intel, Guadalajara, Mexico
“Keep the DRC on most of the time.” 

To read this entire article, which appeared in the October 2015 issue of The PCB Design Magazine, click here.

Share

Print


Suggested Items

‘The Trouble with Tribbles’

06/17/2021 | Dana Korf, Korf Consultancy
The original Star Trek series came into my life in 1966 as I was entering sixth grade. I was fascinated by the technology being used, such as communicators and phasers, and the crazy assortment of humans and aliens in each episode. My favorite episode is “The Trouble with Tribbles,” an episode combining cute Tribbles, science, and good/bad guys—sprinkled with sarcastic humor.

IPC-2581 Revision C: Complete Build Intent for Rigid-Flex

04/30/2021 | Ed Acheson, Cadence Design Systems
With the current design transfer formats, rigid-flex designers face a hand-off conundrum. You know the situation: My rigid-flex design is done so now it is time to get this built and into the product. Reviewing the documentation reveals that there are tables to define the different stackup definitions used in the design. The cross-references for the different zones to areas of the design are all there, I think. The last time a zone definition was missed, we caused a costly mistake.

Why We Simulate

04/29/2021 | Bill Hargin, Z-zero
When Bill Hargin was cutting his teeth in high-speed PCB design some 25 years ago, speeds were slow, layer counts were low, dielectric constants and loss tangents were high, design margins were wide, copper roughness didn’t matter, and glass-weave styles didn’t matter. Dielectrics were called “FR-4” and their properties didn’t matter much. A fast PCI bus operated at just 66 MHz. Times have certainly changed.



Copyright © 2021 I-Connect007. All rights reserved.